|12V, 40A||12V, 60A||12V, 110A|
|High efficiency 40A charger|
3 Power Up Control Mode : Auto-Ignition Feed ,Built-in Vibration Sensor & Input Voltage Control.
6 Battery type selections : 2 of Each in AGM/LEAD/LFP
3 Stage charge for Lead based & a specific 2 Stage for LFP
Optimal Efficiency 92% with Digital Control
The high power conversion efficiency allows quiet and cooling running of the charger and can provide continuous full load
operation at 40°C ambient temperature.
Designed to cover old and new types of car alternators
The SBC-6104 are designed to address to the issues of wide swing of output voltages from the smart alternator, braking regenerative EURO 5/6 vehicles in fully charging the house battery. They are also suitable for use with distant house battery. The charger Booster provides fast safe charging profiles for 4 types of lead based and 2 types of Lithium FePO4 batteries.
This is a select (battery type) and forget charger designed for fast accurate and safe recharge of your deep cycle house battery banks. The (digital control) smart multistage charging enables the charger to be connected permanently to your battery banks without the worry of over charging or drying out the electrolyte.
Lead acid based Battery
A 3 Stage Bulk, Absorption & Float charging profile for 4 types of lead acid based battery with maximum constant charging current at the Bulk Stage and a Constant Voltage with decreasing charging at the Absorption Stage and a reduced voltage Float Charge for maintenance when battery is full.
LiFePO4 (LFP) Battery
A 2 Stage charging is specially for 2 types LiFePO4 battery and charging current stops at the end of Absorption stage.
Three charge control methods:
|Ignition Control:||Charger starts charging only when ignition is on and stops charging when Ignition is off.
This is the recommended control as it is safer and allows for large input voltage range.
|Input Voltage Control:||This is for non-intelligent or older type alternators with sufficient high & uniform voltage.
Charging is cut off easily due to high threshold voltage to protect the starting battery.
|Vibration Sensor Control:||Charger starts charging when repeated vibrations are detected and stops charging when no vibration is detected for over 2 minutes.
The built-in vibration sensor makes it possible to use the charger by just connecting to the starter terminal without touching the car’s electrical/electronic wiring thus avoiding any possible excuse for revoking the car’s warranty.
Remote battery temperature sensor
Bundled remote battery temperature sensor allow the charger monitor battery temperature and automatically compensate the charging voltage according to battery temperature. It protect the battery by cut off output of charging whenever battery temperature are too high or drop below -10°C.
Optional remote control SDR-5100
SDR-5100 remote control is remote panel for Manson chargers. It can be used to monitor charger status and configure the charger. It come with a 4m length cable for you to connect the charger to the car panel. In additional to monitoring and configure the charger, SDR-5100 enable two user define setting for SBC-6104. You can set two customized charging profiles for your battery.